NL810 - FAQ's


Q: I can't seem to install graphics driver on my motherboard because "_Setup.DLL" is not found, why and what is the solution?

Driver

A: Please go to Intel website www.intel.com >> support >> graphics >> i810 >> INF Utility driver. You must install INF Utility driver first in order to have Windows to load the graphics driver. You can also find it on our website, under Drivers.


Q: I can't get the firmware hub to load. How do I make it to load?

Driver

A: After finish installing Windows 98, on the device manager, you will see a unknown device, do not remove it, insert the BCM driver installation CD, than run Intel INF update, then reboot you system.


Q: How do I tell which BIOS version I have?

General

A: When you first turn the computer and the screen displays the Energy Star Logo. On third line down from the top, towards the end of the line it will say either Ver: or Version: and then have BIOS version number.


Q: I have a power LED connector which is 3-pins; but, on the board, I see only two pins and one pin seems to be missing. Is that normal?

General

A: Yes, it is normal for IN810 only (newer models will have it included.) You can use two of three pins, but you will not be able to take a full advantage of bi-color function.


Q: My system clock seems to be slow or stopped working. Is it a problem with my motherboard?

General

A: Yes. But the fix is very easy. Go to any electronic store like Radio Shack and find CR2032 battery. Please follow the instructions carefully:

1) Power down the system if it is not already off.
2) Unplug the system from wall outlet.
3) Remove the system cover.
4) Disconnect the power connector from the motherboard.
5) Carefully remove the CMOS battery (CR2032) from the motherboard and discard it.
6) Install new CR2032 that you bought into the battery holder.
7) Reconnect the power connector.
8) Close the cover, and plug the system.
9) Power up and enter the BIOS settings as you need to re-set the time and date as well as any other configurations there may be lost during the process.


Q: Where is the Serial Number and PWA Number on my motherboard?

General

A: The Serial Number is the long bar code sticker and the PWA Number is the short bar code sticker. They are located on the front edge of the board by the IDE connectors.


Q: How do I identify what model motherboard I have?

General

A: The model number is printed on the cover of the manual. If you lost the manual you can compare your board to the pictures of the motherboards on our website to try and identify your board.


Q: I am having trouble with the on board parralel port. My HP500 all in one officejet can not be found in windows 98. What is the problem?

I/O Port

A: Try to update BIOS to 1.02.02, and setup the printer port to ECP print mode recommand by printer manufacturer.


Q: I am trying to add an IrDA. What is the pin out for the IrDA connector?

I/O Port

A: IrDA Connector pin out is as follows:

1) VCC
2) FIRRX (mode select or fast IR receive)
3) IRIA (IR receive)
4) GND
5) IROA (IR transmit)


Q: I need an IR port for this board. Is this available directly through BCM?

I/O Port

A: No. We are a board manufacturer, not a distributor. We do not manufacture or recommend any IR ports, but we provide the IR pin out information in this FAQ.


Q: Is there anyway of overclocking the video on this motherboard?

Video

A: No.


Can't find what you are looking for?  Please click here.